2016-2023 Tacoma Gas Cap Holder

Before I begin, yes I know the metal clip can hold the gas cap using the little wire that attaches on the door.

But I wasn't happy with that. After printing a few different designs from other vendors/ sites I wanted one where the threads would simply drop in place instead of screwing in.
So, after many test prints I give you yet another gas cap holder.
This one is blank, I have experimented with designs/ logos and they work well on the flat surface to the left and under the gas cap ring. The gas cap is fitted to the existing screw which holds the door closed, and requires nothing other than the printed part
This model was designed for my 2018 Tacoma, and my brother's 2023 Tacoma, but will fit the gen 3 2016-2023 model years.

In the photos the cap can be seen aligning to the threads, but it is not fully dropped down. It will sit lower than my photos show.

Once again the print included is blank, and does not have a pattern on the front. The photos show patterns that I included on my own personal prints which are not being sold.

Since this will be somewhat exposed to the elements, consider your location and print in PETG/ABS/ASA.

Feedback is always welcomed. Your paint thanks you.

Printed on: Ender 3 V2

Print in PETG/ABS/ASA
I printed in Eryone/Duramic PETG @240 and 70 bed temp
Layer height 0.2-0.28
Nozzle 0.4
Infill 25%-Gyroid
Print speed 65mm
Infill speed 70mm

Support is necessary
Print orientation is ring up. Basically print with the back down.