Please keep in mind that they are under a NON COMMERCIAL license, so don't sell the files or prints using this design.
I designed three geometric plant pots for some succulents.
In addition, I created an inside pot for each planter with some holes in their bottom and a little offset from the ground so that excess water can escape.
They were designed to fit small succulents with an inside width of ~60 to ~65 mm.
They are all around the same height (roughly 60mm from the ground).
I would love to see your prints, so if you make one be sure to post a picture under makes.
If you like my designs or have any questions leave a comment and maybe consider a little tip.
I also added an STL file for the base. Mine is made of concrete and not 3d printed, but I modeled it anyway to find out how the planters would look on it.
It is about 260 mm long so maybe you have to scale it down a little bit to make it fit on your print bed.
You may also find some of my files on thingiverse and printables. I made my printables account to get away from thingiverse, but since I heard a lot of good things about MakerWorld, I decided to upload on here as well. I have access to a P1P at work and a friend of mine owns an A1, so I may be able to add some Bambuslicer-specific files in the future as well.