I designed this keyboard mount to get my keyboard away from the window sill to a more uptront and center position.
It is specifically designed to work with the F18 UFC from WinWing and WinWings respective mounts for the device.

The keyboard mount works by just connecting the two main parts with the keystone (keystone printed at 99% scale - already implemented in my print profile) and sliding it into the WinWing mount. No addtional hardware is needed. That being said, a few drops of superglue to connect the parts permanently does help with stability quite a bit, but is not a must for it to work.

I use my Virpil Mounts to hold the UFC to my desk, but I also tested it with the WinWing clamps and it works just the same.

As of now it does not work with the MFDs, but if there is a demand for it I can probably easily adapt it to those, too.

Little additional note: If the mount is printed with Bambu Matte PLA Black it almost looks like an original wineing part that belongs there. I used that on my first version and it looked great. Unfortunately, the model had some funtional shortcomings which is why I will not include pictures here.
I only chose the orange PLA here to make it easier to see how it functions and slides in. With black it is very hard to take a good picture unfortunately.

Print Settings:
I used 3 walls and 15% sparse grid pattern infill, which is plenty strong enough in my opinion.
The mount is designed to print without any supports needed.