Looking to spruce up your office? This two-in-one headphone and phone stand should do just that. Two different versions are available; with or without bubble patterning on the base.

Please see the printing advice provided below in Print Settings.

Note that this is a very large print and may take upwards of 24hrs. Please also check that it meets the size requirements for your phone/headphones. Phones smaller than 68x10mm should fit (thinner phones could be a few mm wider). Also note that some of the above pictures show an earlier version of the design with no phone holder.

Release #2 (13 NOV 2023): Corrected orientation of STL files and provided additional sizing information in description.
                        

Print Settings               

Supports are not necessary since most printers can bridge the overhangs. However, if used, the requisite support material would be minimal and be easily removable.

This is a large print so low infill is recommended (5-10%). Larger layer heights are also advisable to reduce printing times (when printing the base), as will larger nozzles.

Assembly

Once both TOP.stl and either one of the bases has been printed (print ONE of the two bases provided), simply remove the small amount of supports (if used) and glue the two components together using superglue or a similar adhesive.