I printed the original BLV AMS Riser from benlevi (glory to him!).

Sadly I found out that my LED strip didn't work with this version. I have the 8mm LEDs from Bambu Store. It was too late to print one of the other remixes which solve this  problem so I created this frame to add my LEDs to the original riser without printing again.

The result is really nice even though it's just glued on the original riser.


How to build:

- print
- put it on a cardboard so you can really make sure it's flush on the bottom (see picture) and that the TPU parts are higher up so the glass doesn't lie on the LED frame later
- glue the parts in with hotglue
- put your leds in, be careful on the corners not to damage any of the electrical components
- put some standard transparent tape (tesa/scotch etc) over the LEDs so you get a smooth surface. This will be better when your PTFE tubing touches the frame.