I noticed that my drain plug on my Wrangler JL (2018-2024) that attaches to the floor mat was not sealing and water was getting in through the hole making my carpets wet. I still wanted to keep the Mopar rubber mats so I made another plug to seal up the hole better. Please note that there will be a little bump on the floor mat if you do not trim the old plug off the mat. This can be used with out without the Mopar rubber floor mats. THIS MODEL IS SIZED TO BE PRINTED IN TPU! While it will also work with PETG you may have to adjust the scale a tiny bit. I would not advise printing this in PLA as the heat from the car in summer will warp it and being exposed to the elements, it will not last.

PRINT SETTINGS FOR TPU:

.2 Layer Height

15% Gyroid Infill

8 Top and Bottom Layers

Concentric Top Layer Pattern (I have found you get a much better finish with this pattern using TPU)