No Print Profile yet. Add one to earn points.
Here is a self-watering pot for plants. It is equipped with a gauge to check the water level at a glance. It can support different sizes of baskets which are currently 20, 40 and 55 mm.
This pot is designed on the hydroponic principle, so care must be taken to maintain the same level of water.
Print the tanker with an 20 % infill, 15 minimum
Holder, baskets and gauge can be printed with a 10% infill, ideally 15 for the gauge.
I print it at 150mm/s because my printer can do it but 90 or 60 mm/s do the job
It works with PLA but PETG for the tank ensures long-lasting watertightness
Feel free to leave a comment to ask questions, make suggestions or other.
Don't forget to post your make !