If you like this model, please share your print and review it! would be highly appreciated !

• simple, strong and elegant dispensers for Salt and Pepper.
• two model versions, not just scaled up/down:
  • The smaller have also a small tray included in the profile.
  • The bigger ones have no tray added for the moment (if many will request it, I will probably do it).
  • The bigger ones are also a bit more fat. 😁
  • Both versions have the same eye sizes for dispensing salt/pepper.
• easy to open and fill as the cap has groves specially design for this.
• could be a fun little gift.

Printing and technical info:

• no assembly needed, printable without supports. I've tested many settings, tried also with supports, but my best results were without supports, and with special settings for the last part of the print. My profile contains some settings changes for the last part of the angel print.
• Included also brims, to be sure that the parts stick to the plate until the end. For the bigger dispensers, I don't think they are mandatory, for me worked without them. You can take them out if you want.