Stickman balloon knight fight game (block'em pop'em)

This is a fun simple table game, where the objective is to pop the other player balloon.

You need to print:
8 leg (4 for each doll)
2 body (1 for each doll)
4 arm (2 for each doll)
2 forearm sword (1 for each doll)
2 forearm shield (1 for each doll)
2 hand (1 for each doll)
2 shield
2 sword and 2 sword mirrored (sword2)
4 handle
2 support 4mm tube
2 trigger and 2 trigger support
2 base

Hardware needed:

4 3mm screws x 30mm long with washers and nuts (this are for the shields and the hands, the hands should be loose and the shields should stay fixed)

2 3mm screws x 10mm long for the triggers

4 8mm diameter rods x 40cms long (this rods can be of any material you want: wood, aluminium, carbon fiber...)

2 pieces 4mm PTFE printer tube x 25cm long for the trigger system

2 needles for the swords, you need to glue together the two parts of the sword with the needle inside barely sticking out of the sword tip

1/8" (3mm) Elastic cord for all the doll joints

Thin rigid cord or fishing line for the trigger system.

2 little pieces of 14 gauge steel wire to staple the legs to the base

A wooden board for the base of approximately 20 cm x 35 cm, the heavier the better, and 8 screws to fix the bases to the board, I recommend you fix the two dolls 14 cms apart

https://youtu.be/aM4A3XEzv8E

You can print everything in PLA and I use a 20% infill