No Print Profile yet. Add one to earn points.
Needed a minimal friction spool holder for troubleshooting a nasty print issue. Did not find anything that I liked and that would be quick enough to print, so I designed one of my own. This is a single part that is used four times over to create two assemblies that will get your spool rolling.
No fasteners are needed, 626 bearings (ID6xOD19xH6) keep the assemblies together.
My other designs:
mbe Printhead v1.0 - Anycubic i3 Mega S Head with Dual Part Cooling Fans
Printer Brand:
Anycubic
Printer:
Vyper
Rafts:
No
Resolution:
0.16
Infill:
20%
Filament: Anycubic PLA, ABS, PETG
Notes:
Test print one piece first, as this is designed for printing on the speedy Vyper that is tuned for slight under-extrusion in stock configuration. In case the bearing does not fit the way it should, scale the entire model up or down directly in your slicer.