Cell Phone Holder

Transform your nights with our bed-back phone holder. Enjoy hands-free entertainment before bedtime or keep your device within reach while you relax. With its secure attachment system, this holder is the perfect solution for a comfortable and convenient nighttime experience. Discover the perfect blend of practicality and style.

Printing Material:

Use a suitable 3D printing material, such as PLA or ABS, depending on your preferences and requirements.

Layer Height:

Adjust the layer height according to the desired quality. A common value could be around 0.2 mm for a balance between quality and printing speed.

Infill:

You can adjust the infill percentage based on the strength you desire in the supports. A range between 15% and 20% might be suitable.

Printing Speed:

Set a moderate printing speed to ensure accurate printing and avoid potential issues. A common range is 40 to 60 mm/s.

Supports:

Enable the supports option, but configure them as "Normal Support" to facilitate easy removal after printing.

Support Threshold Angle:

Set the support threshold angle to 25 degrees. This means that any feature with an angle greater than 25 degrees from the horizontal will be printed with supports.

Nozzle and Bed Temperature:

Configure the nozzle and bed temperatures based on the recommendations for your printing material. For example, for PLA, you could set the nozzle to around 200°C and the bed to 60°C.

Bed Adhesion:

Use suitable bed adhesion methods, such as a heated bed surface with special adhesive tape or a specific adhesive layer, to help with adhesion during printing.