I created this 45 degree light bar mount do to the poor light given off by the factory 6 light LED strip in the front of the K1 and K1 Max.

This print will let you slide a 10mm or 8mm strip of led's to mount on the inside front and sides of your K1 and K1 Max with 3M tape.

You do not need to remove the led adhesive covering, just slide the strip straight in. I have created this file in 2 lengths, if you require more or less led's, you can resize the length "ONLY" of the .stl file in the slicer.

You will also need a female JST 2 pin connector to plug into the factory male plug. I attached mine to the right side corner snap jumper connector.

LED Lights : https://a.co/d/bBs2krS

LED Connectors : https://a.co/d/7WV4xmA

COB LED Lights : https://a.co/d/h13XLfM

COB LED Connectors : https://a.co/d/ab0gFjG

3M Tape : https://a.co/d/0KRiNH8

JST 2 Pin Connector : https://a.co/d/eMj3O8k

Warning: After further testing and reviews from users, I have to caution you on placing a led strip on the left side of the printer. The cable chain may catch on the led’s causing issues. I therefore recommend only using COB style led's that are covered or placing a light strip in the front, on the right, or both front and right.