Emerald Isle Dragon and Pot of Gold - Threaded (Commercial Use)

This is a Screwtop Pot of Gold that can be filled with anything you feel is at the end of the rainbow - perhaps you will even find a leprechaun or even an Emerald Dragon!

The Full Emerald Dragon at 100% fits inside the Pot of Gold at 100%. The Half Emerald Dragon fills the pot halfway, leaving room for plenty of other goodies or printer waste!

This Download Comes with 3MFs and STLs of all files:
Coin Lid
Pot of Gold (also multicolor)
Half size Dragon
Full Size Emerald Dragon (Also Multicolor)
Reseller Badge

This a Commercial use file - buy it once and sell physical copies forever. If you would like to print for private use only, it is available at this link.

https://makerworld.com/en/models/218648#profileId-237515

 No supports are needed for printing the Emerald Dragon or the Coin Lid:
2-3 walls
10%gyroid infill

Supports Recommended to be Manually painted on three lines each between the Pot feet (They are already on the 3MFs along with a slowed outer wall). See final pictures. It can be printed without, but the bottom may look gnarly. Slow the outer layer for best look.

I also suggest printing with seams at the back of the pot or Bambustudio will try to put it through the shamrocks.

Do not over tighten the coin top lid onto the pot or you might have problems getting it open later; a few light spins closed is all it need to be secure.