St. Patrick's Day Dragon Bundle (Commercial Use)

This is a Commercial Use Bundle of:
Lucky Shamrock Dragon
Emerald Isle Dragon with Pot of gold

Note: The Lucky Shamrock Dragon will not fit in the Pot of Gold at 100%.

The Files included are:
Lucky Shamrock Dragon multicolor/ single color 3MF

Lucky Shamrock Dragon STL

Coin Lid STL/3MF
Pot of Gold (also multicolor) STL/3MF
Half size of Pot Emerald Dragon 3MF
Full Size Emerald Dragon (Also Multicolor) STL/3MF
Reseller Badge

.2 Layer height
2-3 walls
10-15 Gyroid infill

For higher detail on the Emerald Dragon and Lucky Shamrock Dragon lower the layer height. The coins on the lid also look better at a lower layer height.

For a better looking pot of gold, slow the outer layer, and add supports to the bottom of the pot ending at the same height as the feet - there is some rippling at these overhangs for me. The bulge of the pot obscures this for the most part unless the pot is flipped over.

Here is a picture of the supports and 2-3 vertical line supports makes a world of difference for better looking bottom overhangs (Final Pictures).

3MF pot files already have the supports painted on and a slowed outer wall for a nice looking pot. All files can be printed without supports if preferred.

I also suggest printing with seams at the back of the pot or Bambustudio will try to put it through the shamrocks.

Do not over tighten the coin top lid onto the pot or you might have problems getting it open later; a few light spins closed is all it need to be secure.

Printed on Bambu P1P