No Print Profile yet. Add one to earn points.
An adaptation of Matt3ry's Dranzer Spiral for the Burst System.
To assemble it you will need:
-1x Spring (It pushes the Burst System's Lock
-2x Small nails with a round-head (For holding the driver together, like the picture)
-1x Small Spring (for the switch tip)
-1x Blue filament strip
This one is a bit trickier to assemble:
If everything went smoothly, you should now have the switchable mode driver.
You could also use super glue instead of the pair of nails, but It won't be strong enough for some matches. I personally used PLA for this print, and it didn't break after many battles.