Airless Tenis Ball
Copyright Claim
Airless Tenis Ball
Boost
63
95
19
Print Profile(1)
0.2mm layer, 2 walls, 40% infill
Designer
3.4 h
1 plate
Boost
63
95
19
0
309
89
Released
Description
This is my Airless Tennis Ball design. Print it with 40% infill so you can have the real weight of a tennis ball. It prints approximately 16 hours at 50 mm/s on an ender V2 3D printer, so BabmbuLab will complete the task faster and more accurately. The ball has real dimensions. You can print with TPU, PETG, ABS or PLA material, the material depends on the use of the ball.
Comment & Rating (19)
All
Print Profile
0.2mm layer, 2 walls, 40% infill
si no pones soportes quedan los hilos colgando
The designer has replied
0
Reply
t's not because of the lack of supports, but because of the wrong choice of material you used. what kind of tpu was it?
0
Reply
es pla
0
Reply
used green cr tpu and it bounces great on cement floors
The designer has replied
0
Reply
looks great
0
Reply
Print Profile
0.2mm layer, 2 walls, 40% infill
I dont know if it was this profile or the bambu lab TPU, but it could have looked smoother after printing.
Other than that its fine :) maybe just reduce the speeds a bit?
The designer has replied
1
Reply
can you send photo?
0
Reply
you can use hairdryer to remove strings
0
Reply
great print
1
Reply
Print Profile
0.2mm layer, 2 walls, 40% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 40% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 40% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 40% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 40% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 40% infill
0
Reply
License
This work is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld