Fly swatter - No fly zone - TPU+PETG

Amaze your friends, with very resistant (Much more than commercial one), flexible and cool fly swatter. You're not the meat, but make the meat !

Presented after 5 years of research, and billions of cold flies.
Designed for hot and humid climates. Suitable for large insects.
Always copied, never equaled.

The inspiration for Tina Turner's song: The best

Can you print it ?? Easy print, no support, can’t fail.

Find out about the insects protected in your region before use.
Wash hand after use, and store it on the point side, so the mesh does not touch the surface.
No age restriction. Do not eat.

FDM 3D printing
Printing plate 300x300
Up to 120% scale on sidewinder X2 - rotate 45°

Bi-materials: Start with TPU 95A & Finish with PETG
Change for PETG at layer 4 : Initial layer Height : 0,2 / layer Height : 0,2

Infill: 100%
Cooling : 35 % at layer 4

Important : Minimum 2 layers for the mesh.

I printed it with Cura :
Post processing > modifiy GCODE > Filament change > Layer 4
Up to 120% scale on sidewinder X2 - rotate 45°
Printe speed : slow for TPU (30mm/s)
Nozzle : 0,6 or 0,4
Infill: 100%

220-230° until finish
30° Bed temp (With modified textured magnetic plate PEI)
Buid plate adhesion : none or only outside

Tips :
You can finish last layers with TPU, for better grip, and better smash experience.
White color is not a good idea, like replace PETG by PLA/PLA+.