Smartphone Card Stand
Copyright Claim
Smartphone Card Stand
Boost
21
27
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
59 min
3 plates
Boost
21
27
4
1
50
28
Released
Description
This nifty little credit card sized phone stand slips right into your wallet or purse ready for when you least expect to need it
There's two versions available: A vertical and horizontal compatible card and a horizontal only version, this is denoted on the back with the little symbols, for easy identification after printing.
I'd recommend to use ABS or ASA however with my testing Basic PLA has worked fine so far it just fatigues faster than other materials.
Enjoy c:
Comment & Rating (4)
All
Prints great in PLA. Zero issues.
Most stable credit card sized phone stand I could find.
This design offers up adjustable vieuwing angle for ease of use and stability.
The Vertical+horizontal version is less stable and the viewing angle is rather steep. I recommend the horizontal only version.
I can see the PLA wearing out but I easily folded the hinges 50+ times without any noticeable damage.
In any case, a great "in case of emergency" phone stand to keep in your wallet.
The designer has replied
1
Reply
Thanks for the comment, glad that It'll somewhat suit your need aha
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Good print quality and it works perfectly (vertical version)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:hält nicht. fällt laufend um
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld