Govee / LED CheapBest Lightbar

This is the cheap & best option to create an amazing Room Illumination!

You get indirect homogeneous light, better than much diffuser!

What do you need?

RGB/IC LED Stripe as desired. (Should be arround 10-14mm depth, they almost have 10mm!)

Cheapest Cable Channel from your Hardware Store 15x15mm 2Mtr. Long.

As much as you need for your Strips length! (And one or 2 extra for some corners)

The STL file printed , at minimum 2x per Cabel Channel (2mtr)

Some small Nails or Screws (1,5mmx??mm)

First you Print the needed amount of holders, then/inbetween you get your Cable Channels (arround 1,30€/2Mtr/Piece.)

So then the easiest was to Grab a clothepin as Distance Keeper between the holder and the Ceeiling, fix at minimum 2 Holder per 2 Meter Channel Piece or shorter pieces as needed.

Remove all Caps from the Cabel Channels and Throw them aside. Now you get one of them and cut it in arround 10cm pieces, you need that to fixate the stripes while installing and then to connect the Cable Channels (they Keep open to let the LED seine against your wall and ceiiling.

The holder is 5 cm from the wall and should be 5 cm under the ceiling.

Grab Light Wighte Cabel Channels ! If you want it perfectly buy a White permanent marker too , to color some Informations who are sometimes at the bottom of these channels.

I didnt use the glue Strips coz the angle and the gravitiy hold all in perfect place!

This is a very lightweight and self stabilize installation which you could do even on Walls where the Nails dont get throug.

The Channels Stays open so the LED can Illuminate directly to the wall / Ceiling.

Its incredible Cheap and (i think) better than the most Diffusor Channels...

0.2 Resolution

3 Walls

White filament