This is a carrot screw top container for filling with easter candy and goodies! It can easily hold a few regular size bags of candy or even all of my tiny outside of the long necked ones ( plesiosaurus and brachiosaurus - necks make them harder to get out).

There are 2 carrot top versions a stem type and a leaf type, both work with this container with no resizing necessary.

Both parts of the carrot can be printed without supports, but the carrot bottom may look a little messy due to overhangs if you do not. The 3MF carrot bottom already has supports painted on - slowing the outer edge more than what I have may also help, but I am satisfied with the settings I set it at. The supports have a slightly bigger brim so that they connect to make it easier to remove from the plate.

Seam settings - The rainbow silk carrot bottom was printed with seam setting on “random” in hopes of it looking like tiny hair dots. It adds a little more texture. I personally like the look of it “aligned” a bit better personally though.

For better looks slow down the outer wall.

As this is a threaded container, over tightening the lid could break it.

Note: It you are printing the stem style top for the carrot, avoid Matte filaments as the stems might be more prone to breaking along layer lines.

The rim of the bottom part of the carrot may also have a few filament strands that need pulling off as well depending on the filament (rainbow silk was perfect for me, but the clear red needed a little cleaning).

Thank you for checking out my Carrot Container, I have a fillable carrot container also have a Greater Easter Dragon made for Easter as well!