This is a slim Poop Chute for the P1 or X1 Series and is great if you dont have much space behind the printer like me and dont want the poop going around the side so its nice and tidy.

The dimensions are 120mm wide 55mm in depht and 184mm in height, so that you can place the printers back as far as possible against a wall so it doesnt need much space.

I was looking for a Poop Chute for my specific application but did not find the right one for me, so thats why I decided to design and make my own, as I dont wanted to have a Poop Chute that wraps around the corner.

This is the right Poop Chute for you if you are searching for the following requirements:

→ Slim design, fits behind the printer; leaves the space on the side of the printer nice and tidy

→ Large capacity, so you dont have to empty it as many times (depending on your use case)

→ Easy to print, no supports or magnets needed!