Introduction: Illuminated Jack O Lantern Ring
This started out as a project to 3d scan a pumpkin made out of clay, then it morphed into an illuminated ring.
Step 1:
First, I made a jack o lantern and scanned it.
Step 2:
Next, I printed the pumpkin, then made a ring in 123D and printed that.
Step 3:
To create a hole for the LED, it was necessary to cut the pumpkin in two pieces and scan them separately.
Step 4:
I combined the pumpkin front, pumpkin rear and ring (stl files) in Tinkercad--to create one file for the ring.
Files are available at:
http://www.thingiverse.com/thing:163387
Step 5:
Last, I added a 2032 battery and a white led, just bending the led legs enables contact with the battery and prevents the battery from sliding out.