Made this for a coworker, since I couldn't find it already designed on the internet.

Standard setting with Bambu Slicer. Has not been printed on any other printer.

I used 7 strips of leds cut to length and installed on the back flat. Put a drop of super glue on each side of the strip every couple of inches to hold it in place and sprayed with accelerator.

Black Super Glue, if you want to glue the back on.
https://www.amazon.com/dp/B00C32MMFO?ref=ppx_yo2ov_dt_b_product_details&th=1

Inline Switch
https://www.amazon.com/dp/B00C32MMFO?ref=ppx_yo2ov_dt_b_product_details&th=1

Led Strip, makes a few lightboxes!
https://www.amazon.com/dp/B082J65TK8?ref=ppx_yo2ov_dt_b_product_details&th=1

Wire
https://www.amazon.com/gp/product/B00QTCBZ4I/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

These are the adapter jacks I like to use, but any jack will be fine as long as it matches the wall adapter.
https://www.amazon.com/CenryKay-DC-099-Threaded-Connector-Adapter/dp/B08CMMQMP6/ref=sr_1_28_sspa?keywords=dc+jack&qid=1707080429&sr=8-28-spons&sp_csd=d2lkZ2V0TmFtZT1zcF9idGY&psc=1

Wall adapter 12V 1amp. These have went up in price, just make sure it matches the jack. I usually get these in a 2 pack for this price. Just shop around.
https://www.amazon.com/Anlink-Regulated-Adapter-Security-Surveillance/dp/B07WQQZGXB/ref=sr_1_19?keywords=12v%2B1A%2Badapter&qid=1707081105&sr=8-19&th=1

3D PRINTING SETTINGS

Printed on Bambu Lab with 2 Ams's
pretty much all Bambu Lab filament including the CMYK pack
All standard settings except I added Ironing on all flat surfaces to eliminate any pin holes. So that adds to print time. Printing time for the front is around 11hrs. Make sure to spray the textured pei plate with Auquanet super hold hair spray and run the bed temp around 35C. Too much heat and no extra sticky will allow it to warp(curl up on the edges).