Meta Quest 3 reinforced gunstock compatible with AMVR silicone grips (any silicone grips)

Please, respect that purchase is valid for print for one person. It means, if you break something, you can print it again. However, please, do not print Gunstock for friends or anyone else without my approval.

Magnetic reinforced Gunstock (R-Stock MK2)
This gunstock is compatible with AMVR silicone controller grips (for Quest 3 controllers) and with most 3rd party silicone grips. It is also compatible with standard Quest 3 grips provided you use silicone strips inside of the cup.

Upon 10 sales I will design standard cup holders for usage without silicone grips and add to the files for free.

Why new gunstock when they are lot of in market?
In general most of them does not support silicone grips. This one do. I already purchased 2 gunstock and issue was - they were not strong enough and got cracks and damaged during gameplay, not saying about bad compatibility with the silicone grips.
Hereby I designed new one - reinforced and supporting the grips, while keeping the weight down. Total weight without controllers is 535-540g.

This purchase contains all the files needed for print prepared in 3mf format. Additionally you will have to buy some metal parts, magnets and of course tube.
*If you want to buy a complete parts set (without hassle and looking them on internet), just contact me at boardgame3dparts@gmail.com *
- 1m 20mm tube (thickness 1mm, so inside diameter 18mm). I suggest to buy one from me, as I am selling lightweight carbon tubes (not a fake carbon tube with sticker). It includes a spare part length.
- 2x nylon M3 nut
- 2x 8mm M3 screw (countersink)
- 12x 34mm M6 screw
- 12x M6 nut
- 2x magnet in case 7x20mm
- 2x magnetic washer 20x1.5mm (with M5 countersink hole)
for better choice/adaptability and to be able to setup magnetic attraction power I recommend buy also:
- 2x magnetic washer 20x1.5mm (with M5 countersink hole)
- 2x magnetic washer 18x1.5mm (with M5 countersink hole)
these can be used for better magnetic attraction setup.

Print with PETG (no PLA!)

For your convenience there are 3MF print files set for Prusa slicer. (compatible with all PRUSA and all Prusa clones)
Everything is preset, just select your filament brand generate g-code and print.

Minimal support required.
Brim required on cups.

Special print setup for reinforcing:
5 top layers, 4 bottom layers, 4 perimeters (walls)
Infill 40%, honeycomb infill