Golem organizers

Organizers for Golem board game. Quick game set up and comfort during the play. Sliding lids prevent components from falling out during the storage. Theme reliefs and cutouts decorate organizers.

The set contains: Resources organizer, Player's component organizer, 4 Card trays, Action holder and Hammer organizer.

1. RESOURCES ORGANIZER: A large organizer with 10 sections. 3 types of resources tokens in 3 values are accommodated here. Sections are adjusted to the size and quantity of each value. The largest section is for gold pieces. Rounded bottom facilitate the draw.
2. PLAYER'S COMPONENT ORGANIZER: All components of one player are accommodated here. 3 types of Development tiles are kept in separate rooms. All wooden markers and Summary card are kept in the largest section. 4 such organizers must be 3d printed for 4 players.
3. CARD TRAYS: There are 4 decks in the game: Book, Objective, Character and Solo. There is a tray and a lid dedicated for each deck. They all have the same sizes, but reliefs and cutouts are different. Sloped bottom and indentation facilitate the draw. Additionally there are 2 simple inserts adjusted to the tray dimensions. Insert1 is dedicated for components of the solo mode. It fits the Solo tray. Insert2 is dedicated for Pass tiles and Menorah tokens. 2 sections separate them comfortably. The insert fits the Character tray. Trays are adjusted to cards without sleeves.
4. ACTION HOLDER: All Action tiles are kept here. Slightly sloped bottom and indentation facilitate the draw during the play.
5. HAMMER ORGANIZER: Neighborhood tiles in 3 colors are accommodated here in 3 sections. Indentations facilitate taking tile out.

All organizers fit the game box and provide quick game setup. However it's not an insert. Sliding lids prevent components from falling out during the storage. I keep Starting tiles in the textile bag to facilitate the blind draw.
The game box is so large, still it was difficult to design comfortable organizers that fit there well. There is no dedicated container for Marbles and Difficulty level of Automa mode. They are stored in the Synagogue structure - see the last picture. Packing stages are shown in photos.

Some photos in higher resolution:
The set
Organizers
Packing stages

All organizers were 3Dprinted on Prusa MK4 (with Input Shaper):
- in PLA (F3D Gold Pearl),
- No support is needed,
- Infill 10-15% gyroid/rectilinear.
Note1: I use slightly changed default Print settings "0.15mm SPEED MK4" in PrusaSlicer.
Note2: Lids and guides are adjusted to 0.15 mm layer height.
Note3: Monotonic lines as default Top fill (it increases quality of lids).

Printing Time (for one item of each kind):
3h29' - Resources organizer, container
2h9' - Resources organizer, lid
1h32' - Player's component organizer, container (x4)
1h14' - Player's component organizer, lid (x4)
~1h10' - Card tray, container (4 types)
~25' - Card tray, lid (4 types)
~25' - Insert (2 types)
49' - Action holder, container
12' - Action holder, lid
1h16' - Hammer organizer, container
26' - Hammer organizer, lid