A very large Bathroom Organizer with drainage and drain hole. This is a 2 piece design, the bottom is slanted with a drain hole to allow water to drain from the bottom. The top uses the infill pattern (grid or rectilinear) to allow the water to drain through to the bottom piece.
Printing instructions (0.4 nozzle with 0.2mm layer height)
I used PETG (OVERTURE Marble PETG & OVERTURE Sparkle blue PETG) for mine, however I believe PLA should be sufficient for this print. I would avoid the use of ABS and ASA because this will be in the bathroom and any acetone containing products will melt and deform them.
Should be an easy print, doesn't need any supports or brims and mine has held up for a little over 10 months now with no changes.
Please drop a like if you print and enjoy this design.