Fidget Spinner, Print-In-Place, Printed Bearings Remixed by JJTechPrints

Remixed by

JJTechPrints

Toys & Games>Other Toys & Games

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.25mm layer, 2 walls, 10% infill

Designer

21 min

1 plate

4.3(4)

Boost

Released

Description

Remixed from “Fidget Spinners - 608 Bearing Fully Printable” by @endHDesign is licensed under Creative Commons Attribution 4.0 International License. The original design can be found at https://makerworld.com/en/models/231713#profileId-254047

This remix prints the fidget spinner as one part, instead of three separate parts. The original design needed to be super glued together, while this one is ready to use immediately after printing.

Enjoy!

Comment & Rating (7)

@hollowmaker

Boosted

Print Profile

0.25mm layer, 2 walls, 10% infill

Very cool design! Thank you!

@Phattwizat

Print Profile

0.25mm layer, 2 walls, 10% infill

It printed fine, spins, but the weight and tolerances are such that its not very satisfying.

The designer has replied

@JJTechPrints

Thank you for the review. I agree about the weights. I also want to modify it a bit to have less sharp edges so it's more enjoyable to hold in the hand. And the fast print time is achieved by printing at really large layer height, which makes the tolerances less desirable. I'll try to improve on both of these issues in future design.