As mentioned earlier, this is a functional 20mm hollowed-out air filter with a decibel reduction bar designed for SACHS mopeds. In my experience, the decibel reduction feature is somewhat effective. Depending on your setup, the filter will provide ample airflow.

1 | IMPORTANT ||||||||||

• Printed on a Bambu Lab XC1
• All printed in PA12 by eSun (Nylon is durabale against Fuel & Oil)
• Support is sadly needed.
• I take no responsibility for any damage done to your moped by my designs; use caution!
• Always check the law if you're allowed to install them; also, here I take no responsibility if you get in conflict with your local law. I suggest only using it for showcasing purposes.
• Thight fit, might need to push it a bit.
• 3x M5 screews needed
• 1x M3x5 screew needed

2 | PRINT SETTINGS ||||||||||

• Walls: 3
• Infill: 50%
• Infill Pattern: Gyroid
• No Brim
• Support: Tree (manual)
  Orientation: Flat

3 | DRAW SUPPORTS ||||||||||

If you like this Design, share some Love 🧡 & leave a Like 👍