Pikachu Headphone Stand - Pokemon
Boost
82
131
8
Print Profile(2)
0.12mm layer, 2 walls, 30% infill
Designer
16.5 h
1 plate
SPLIT IN THREE PARTS / 0.12mm layer, 5 walls, 30% infill
Designer
16.9 h
3 plates
Boost
82
131
8
1
155
30
Released
Description
Custom designed Pikachu tail headphone stand. The equilibrium point has been optimized so the model does not fall over. It will be able to accomodate small to medium size headphones without any issues!
The print does not need any support. Please do not print it with a layer height superior to 0.12mm. Set wall loops to 4/5. Set ironing to ‘Top Surfaces’ with a speed of 60mm/s, a flow of 22%, and .12mm of spacing.
The model is AMS ready!
Comment & Rating (8)
All
any chance you could split the model into 3 parts please so i can print it and glue it together :) just from the base to the middle bit and then then top :)
The designer has replied
0
Reply
I have added a new print profiles where the stand has been split into three parts!
Can't wait to see your print!
1
Reply
Replying to @pppardon
amazing :) Thanks soooo much :) gonna print it tomorrow
1
Reply
Boosted
Any chance I can sell this online?
0
Reply
or just two parts :)
0
Reply
Print Profile
0.12mm layer, 2 walls, 30% infill
1
Reply
Print Profile
0.12mm layer, 2 walls, 30% infill
1
Reply
Print Profile
0.12mm layer, 2 walls, 30% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld