Printer used: Ender 3 S1 pro
For most files with large dimensions, the following parameters are recommended:
Layer height: 0.2 mm
Wall thickness: 0.8 mm
Wall line count: 2 mm
Horizontal expansion: 0.0 mm
Top/bottom thickness: 0.8 mm
Top thickness: 0.8 mm
Top layers: 4 mm
Bottom thickness: 0.8 mm
Bottom layers: 4 mm
Filling density: 50% (minimum)
Filler pattern: concentric pattern is recommended as it has shorter printing time.
Speed: 50
Enable retract: YES
Cooling:
Enable print cooling: YES
Fan speed: 100%
Fan speed: 100%
Fan speed: 100%
Generate support: YES
Support structure: YES
Support placement: Everywhere
Support cantilever angle: 45°
Bracket pattern: Zigzag
Support Z-distance: 0.2 mm
Support top distance: 0.22 mm
Bottom support distance: 0.22 mm
X/Y distance of the bracket: 0.8 mm
Horizontal expansion of the bracket: 0.0 mm
Type of adhesion to the printing plate: (required in "FACADE" files): Edge
Minimum skirt/edge length: 25.0 mm
Edge width: 8.0 mm
Edge line count: 6
Edge distance: 0.0 mm
Note: for files such as windows, or lampposts support is not necessary and a filling of at least 80% is recommended as they are thin elements and need some resistance.
The project is easy to assemble, however, elements such as windows need glue to attach to the building. It is recommended not to use "super glue" type glue because it is not very dense and leaves stains when it dries, it is preferable to use glue for hard plastics.
Being a modular product it is possible to print from just one gate to a total of seven gates. The total length exceeds one meter in length.
Dark gray, light gray, yellow, translucent blue, translucent blue and transparent PLA have been used.
VERSIÓN ESPAÑOLA:
Printer used: Ender 3 S1 pro
For most large files, the following parameters are recommended:
Layer height: 0.2mm
Wall thickness: 0.8mm
Wall line count: 2mm
Horizontal expansion: 0.0mm
Top/bottom thickness 0.8 mm
Top thickness: 0.8mm
Top layers: 4 mm
Bottom thickness: 0.8mm
Bottom layers: 4mm
Filling density: 50% (minimum)
Filling pattern: concentric pattern is recommended because it has less printing time.
Speed: 50
Enable retraction: YES
Refrigeration:
Activate printing cooling: YES
Fan speed: 100%
Generate support: YES
Support structure: YES
Support Placement: Everywhere
Support cantilever angle: 45º
Bracket Pattern: Zigzag
Bracket Z distance: 0.2mm
Support top distance: 0.22mm
Bracket bottom distance: 0.22mm
Support X/Y distance: 0.8 mm
Horizontal support support expansion: 0.0mm
Type of adhesion to the printing plate: (required in "FACADE" files): Edge
Minimum skirt/brim length: 25.0 mm
Edge width: 8.0mm
Border Line Count: 6
Edge distance: 0.0mm
Note: for files such as windows or streetlights, support is not necessary and a fill of at least 80% is recommended as they are thin elements and require some resistance.
The project is easy to assemble, however elements such as windows require glue to attach to the building. It is recommended not to use "super glue" type glue because it is not very dense and leaves stains when it dries; it is preferable to use glue for hard plastics.
Being a modular product, it is possible to print from just one boarding door to a total of seven doors. The total length exceeds one meter long.
Dark gray, light gray, yellow, translucent blue PLA and transparent PLA have been used.