Do you like fidgets? I love them, but they are becoming boring and almost the same model everywhere.

Here's my new toy. Built from the ground up to give you lots of wasted time spining that sweet tire.

This is a print in place fidget! No assembly! No gluing parts! No printing parts without an end! Just choose your color combination and if you prefer normal or low profile tires and send it to the printer.

Every part of this fidget is highly customizable. You can color every part of the rim as you wish. Nuts, center cap, outer rim ring, inner rim, tire and the rim itself. Create lots of combinations or paint it like your own car and make it yours.

Read the instructions after this please!

Instructions: In the profile are both versions, a normal Tire profile and a low profile Tire, pick one or both to print. After the print is finished, let it cool or you will risk that the inner rim gets soldered to the tire part. If it doesn't come lose already from the plate, give it a little wiggle back and forth and it should become free and spining with only a few twists. It spins really well after a few minutes, as you can see from the video i posted. Don't change any setting in the profile. Clearances are tight enough for this to work!

In my MakerWorld profile are two diferent Rim designs available. Check the one you like. More coming in the future or if there is a request for it.

As always, if you liked this design, check my other models too.