Just a nice little hueforge moon phases print. The image was sourced from an work on wikimedia commons titled “Lunar Phases” by David Warrington licensed under https://creativecommons.org/licenses/by/2.0/deed.en. I removed the border around the image and the title “Lunar Phases” because I didn't think it printed very cleanly.

The layer heights are set to 0.04mm and a warning will pop up saying that may cause issues with your printer, but as you can see from the first image it didn't cause any problems with my A1.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

Filaments Used:
PLA Spool3D Black Transmission Distance: 0.3
PLA M3D Grey Transmission Distance: 2
PLA Bambu Tough Silver Transmission Distance: 3
PLA Jayo White Transmission Distance: 6.3

Swap Instructions:
Start with Black
At layer #12 (0.6mm) swap to Grey
At layer #22 (1mm) swap to Silver
At layer #34 (1.48mm) swap to White for the rest.