Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
46 min
1 plate
Boost
4
11
6
1
21
20
Released
Description
This one is inspired by Würth-s glove holder.
Use your existing carabiner or print your favorite to clip it to belt or strap.
If you like it, don't be afraid to show it ;)
Comment & Rating (6)
All
Boosted
Printed with eSun ePLA-Lite and it is very smooth to clip on.
Thank you for the nice and simple design!
The designer has replied
1
Reply
Thank You,
Happy cliping ;)
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
great
The designer has replied
1
Reply
Thank You,
Happy cliping ;)
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
Strength Issue:not strong enough to hold gloves had to heat and bend so jaws actually close
The designer has replied
0
Reply
What material did you use? As you can see on the pic it holds really well a pair of relatively thin gloves. If you put a single ply of towel there, it sure will not hold, because it was not designed for that.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld