No Print Profile yet. Add one to earn points.
一个懒得搞,懒得花太多钱又急着用的产物
两个用来固定在机器上的·M3螺丝圆心距离是16mm
装这玩意还需要:
一些M3和M2热熔螺母
一些M3和M2的柱头螺丝
一个9g的舵机和配套的舵机臂
一小段mgn7线轨(孔间距15mm的)
一个mgn7滑块
一根橡皮筋
临时画的,能用就行了要什么自行车XD
A product that is too lazy to make, too lazy to spend too much money and in a hurry to use
There is two screw to put this tiny thing to your machine, The distance between the center of the M3 screws is 16mm
To install this thing, you also need:
Some M3 and M2 hot melt nuts
Some M3 and M2 column head screws
A 9G servo and matching servo arm
A short section of MGN7 linear guideway (hole spacing 15mm)
One mgn7 slider
A rubber band
Temporary drawing, can be used on the line XD