My 1st Hueforge (and 1st upload to makerworld) from scratch and doing it for a birthday present for my son. Have downloaded a couple that I found here and love Hueforge so decided to try for myself. Took me a couple of times to get a print I was happy with. Original photo was taken from a web search and tried to add color but wanted the print to match the AoS color so went with black and white in the end.

Color swap information:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Jade White Transmission Distance: 4
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Jade White Transmission Distance: 4

Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Jade White
At layer #23 (1.92mm) swap to Black
At layer #28 (2.32mm) swap to Jade White for the rest

I uploaded screenshots of my setting cause I used that to help with thickening the print and looking at different setting so figured I will do the same to maybe help others.

Printed on a P1P with AMS but AMS is not needed. With no AMS just pause the print at layer location and manually change the filiment.

I hope everyone enjoys and looking forward to seeing everyone else finished print that choose to print this.