⭙ Grenade Bic Holder ⭙ Remixed by TripleGWorkshop

Remixed by

TripleGWorkshop

Props & Cosplays>Replica Weapon

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

3.1 h

1 plate

4.4(8)

Boost

Released

Description

It's going to say it has errors, just print it anyways!

Based off Peter's Grenade and my warped mind. Fits Bic lighters but might get you in trouble and it's big for pockets. +Brims + Some supports

Original: https://www.printables.com/model/669753-grenade/files

Had to do some rebuilding and adjustments to adapt the grenade model. Re-enforced the spoon (release lever) and made a new pull ring that is more printable and less likely to break off.

Comment & Rating (18)

@TonightWePrint

Print Profile

0.2mm layer, 2 walls, 15% infill

fun model thanks!

The designer has replied

@TripleGWorkshop

Did it not go down all the way? Should fit snugly

@TonightWePrint

Replying to @TripleGWorkshop :

It does, I just didn't push it all the way down in the picture

@MomsMustache

Printed great and was pretty strong. Wear it on my vest all day at an airsoft event yesterday with no issues. Got lots of compliments and I'll be printing a few more for my friends.

The designer has replied

@TripleGWorkshop

@micahbogue

awesome model, however....where's the bic mini version? lol I guess I could scale it down?

The designer has replied

@TripleGWorkshop

I forgot about the minis, maybe scale? I haven't made any mini cases

@micahbogue

Replying to @TripleGWorkshop :

if you rescale it, I'll make one tonight

@TripleGWorkshop

Replying to @micahbogue :

I dont have a mini to measure and test with. I dont release without testing

@Bretthtml

Print Profile

0.2mm layer, 2 walls, 15% infill

cool idea but the tolerance is definitely need a little bit of work. I'm sure someone else has stated would benefit from a small hole at the bottom to be able to relieve some of that air/suction that gets stuck in there when inserting or taking out the lighter but from my experience with this model the lighter is just too difficult to insert and get out.

The designer has replied

@TripleGWorkshop

I figured the vacuum would help keep it in. Feel free to remix it

@6xg4vty98s

Print Profile

0.2mm layer, 2 walls, 15% infill

I like this. There was so much suction trying to remove the lighter, I'd suggest a smaller hole straight through to relieve the suction pressure.

@micahbogue

no hole, the it's meant to hold it in place that it doesn't fall out, but you could use a negative modification.

@simienron

Print Profile

0.2mm layer, 2 walls, 15% infill

Pretty well

@user_423158581

Print Profile

0.2mm layer, 2 walls, 15% infill

Support Issue

Bed Adhesion Issue:there's very little surface area for bed adhesion. You'll need to either need an bed adhesive additive, or just paint on supports to help stabilize the print, or slow it down.