This piece works on 2009-14 Kia Sorento, but has been reported to possibly work with 2015 and 16. May work on Hyundai Santa Fe 2014-15. I clipped off the raised center of the vane it fits on. The clips with the tab down and on the right side is a left vent and center right vent clip. The tab on the left, when pointing down, is for the right and center left. So, if you're needing a full set, two of each will need to be printed. Kia and Hyundai won't sell just the clips, but want the owners to purchase entire new vent assemblies. There are aftermarket companies that make replacements, but they aren't cheap.

They are sometimes called vent clips, vent slides or vent tabs. When installing, they are slid back on the center horizontal vane where the protruding tab will locate the center vertical vane in between the fingers of the protruding tab.

The 3d printed pieces need support enabled and should be printed on there side in PETG, ABS, or higher temp PLA+ (they need to stand up to the heat of your vehicle). They may require some smoothing after printing, especially in between the fingers of the tab.

Step files and f3d files are included so please feel free to modify or change whatever you need.