Lead Screw Shield with magnet 5.0 by FrancescoM

FrancescoM

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

Shield 8x3mm

Designer

2.3 h

2 plates

4.9(25)

Shield 10x3mm

Designer

2.3 h

2 plates

4.7(6)

Boost

101

117

Released

Description

The right and left have two different sizes, you need to print both

This is my new 5.0 project.
The covers have measurements of 26mm on the right side and 33mm on the right side.
It has been reinforced with 2 10x3 mm or 8x3 mm magnets.

Don't leave negative comments, but useful advice to improve the project, so as to help the community grow.
Thank you

Comment & Rating (75)

@minimax

Print Profile

Shield 8x3mm

This is great design; thin but fitted well with Bambu ABS. Printed both on the same plate (0.16 Optimal X1C Profile), which I feel is good compromise as oppose to full length coverage but multiple plates. Thank you for sharing 🙏

(Edited)

The designer has replied

@FrancescoM

Thank you for great rating

@minimax

Replying to @FrancescoM :

This model needs retaining clip though to prevent them sliding up (due to movement/vibration over time) and be within the nozzle travel path.

@FrancescoM

Replying to @minimax :

in these days I will create a version with fixing clips. thanks for the advice

@ale3D

Boosted

Print Profile

Shield 8x3mm

printed in ABS, wonderful project!

The designer has replied

@FrancescoM

Thank you for great rating

@Shinjy01

Print Profile

Shield 10x3mm

Perfect print

The designer has replied

@FrancescoM

Thank you for great rating

@hedoth

Nice look and fits perfect. I would prefer the magnet pockets flat on the back or with two beams an a pocket. So you can place more magnets at the back to increase the field if like in my case the magnets are rather weak. You can see where I placed mine until the glue is cured.

The designer has replied

@FrancescoM

Thanks for the suggestion, but I prefer to leave the old system where the magnet is hidden and not visible. I would be happy if you create a remix of my version

(Edited)

@SevenxMinutes

Print Profile

Shield 10x3mm

Came out beautiful, printed in elegoo black + bambu pink to match all the other pink and black accessories I have added to my p1s.

(Edited)

The designer has replied

@FrancescoM

Thank you for great rating

@Okietronics

Boosted

Print Profile

Shield 8x3mm

Perfect fit and perfect for what I needed!! Was getting tired of my big hands getting grease from the screw rods.

The designer has replied

@FrancescoM

Thank you for great rating

@tobi1980

Sind sehr schön und passgenau aber warum sind sie ein paar cm zu kurz?

The designer has replied

@FrancescoM

to check if there is any print residue in the worm screws.

@Sw7897897

Print Profile

Shield 10x3mm

The designer has replied

@FrancescoM

Thank you for great rating, I saw that your print base is not very clean, I advise you to print my very useful project ;-) https://makerworld.com/en/models/409668#profileId-311578