Minnesota Wild - NHL Hueforge

The rest of my NHL Hueforges can be found in this collection here:
https://makerworld.com/en/u/4065522623/collections/549654

I have assigned the model to have a variable layer print height, which means that the first 4 layers of the model will print with a 0.16 layer height, and switch to a 0.08 layer height for the details. If you use my uploaded print profile this will save you time on your print as the first 0.64mm is just to provide stability to the print for display. This means that the layer heights listed below in my printing instructions will not match my print profile (they will be off by 3) but the mm heights will still match! Do not change the print profile to match or it will not look the same!

If you resize the model make sure you do NOT scale the Z axis or the print colours will not be in the same position

The pictured Frame is a friction Fit design here for 200x200 Hueforges
https://makerworld.com/en/models/381229#profileId-281475

And if you scale it down, I have frames for 100x100 or 150x150 here:

https://makerworld.com/en/models/173529#profileId-190705

Please post a picture of your printed copy! I'd love to see it!

— Printing Instructions---

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Matte Pine Green Transmission Distance: 1
PLA Sunlu Red Transmission Distance: 5.1
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA Generic White Transmission Distance: 3

Swap Instructions:
Start with Pine Green
At layer #12 (1.04mm) swap to Red
At layer #19 (1.6mm) swap to Yellow
At layer #23 (1.92mm) swap to White for the rest.