This pot is available in three different versions:

Without holes (but nevertheless permeable to ensure the circulation of water but avoid the circulation of soil particles) => to be preferred for use with soil.

With 0.75mm holes => to be used with a foam or perlite type substrate

With 0.5mm holes => Same

The difference between the two pots with holes is its use. Choose the 0.75mm for a plant with large roots that would risk breaking the one with smaller holes.

The 0.5mm is for other plants or if you plan to break the pot to extract the plant (there are more holes and is therefore more fragile).

Their printing is done without support in 19 minutes for a room for less than a meter of filament. They are reusable (I have already used my set of 24 pots three times).

Consider using a layer height of 0.25mm (although in 0.2 it works perfectly) to ensure permeability.

This model is designed for the Yoocaa hydroponic lamp but I think it will be compatible with most mini hydroponic garden models.

If you have problems depositing your plants, use a plant label to scrape the space between the pot and the soil.

Tip: For the model without holes, you can get tiny holes if you set the beginning of the layer “random”

/! \ If your jar does not fill with water when you put it in place, scratch the bottom with your nail ;D

Do not hesitate to post comments!