The LegionStay - A Lenovo LegionGo / Logitech MX Keys Mini Dock/Stand

When I bought the LegionGo I didn't anticipate wanting it to become a tiny laptop. But things change, and here we are.

This is designed to slide in/out your LegionGo, but to keep the Logitech MX Keys Mini in at all times. If you put the LegionGo in without the keyboard it will tip over.

There is a version split into 2 pieces for smaller printers, and a version for larger printers.

The 2-piece version will require supports for the USB-C cutout. The 1-piece version will require supports for the keyboard slot.

Has a slot for a right angle USB-C adapter for charging. I used “XAOSUN 240W 90 Degree USB C Adapter | Right Angle USB C to USB C Adapter 2 Pack | USB Type C 240W Connecter | for Thunderblt 4, ROG Ally, Steam Deck, Switch, Phone,Tablet and More ”: https://www.amazon.com/gp/product/B0C3CR8GG5/

Hopefully someone else has some use for this!

Changelog!

SPLIT IN 2 PIECES VERSION

v2 - chunky slide in connector. This could be glued but they fit in tight enough so that it doesn't need to be glued.

• I also changed the angle/length of the arms that support the LegionGo. Just a little. (made them lower at the front and higher at the back)

v1 - original version with “pins” and slots for magnets. My pin bits kept snapping off so I'm editing it and trying a v2 without them.

• I put some pegs for alignment and some gaps for magnets. But you could just glue it. Magnet holes are for 8x3mm neodymium magnets.
• I printed at 15% infill (gyroid), but it's important to increase the infill for the little pins. Otherwise they might snap off.

SINGLE PIECE VERSION

v1 - This is a single piece version to be printed on larger printers. Will require some supports for the keyboard slot.