You've come this far with your organization, i'm going to go out on a limb and assume that you, like me, have some level of OCD.

I wanted to have a nice place to store my labels while they are loaded in my AMS so they aren't just sitting off to the side to get lost or look like clutter. This works out pretty slick! Take your label off your spool and slide it in this display/mount and you can easily see/remember what you have inside. Its even more effective if you share your printer with someone else, it will always be clear what filament is loaded in which slots.

I accidentally left one of these attached to my filament during a print. It actually printed just fine with it on so i thought i might be able to just leave them in place, but the retraction of filament is the problem, it spins with the spool so there are 4 or 5 loops of filament over the top of this label which causes issues when it loads the filament back in.

I designed this to use a little square of 3M VHB Double sided tape, so there is a .5mm recess on the back so this display will sit flush on the front of your AMS. I've also included a flat backed one, if your tape isnt thick enough or whatever.