MST RMX centre console

This model is designed to fit the 1/10th scale mst rmx chassis although it may be able to fit other chassis with a similar design ( It has only be test fitted on the rmx so no promises it will fit on anything else).

It slips over the upper deck and can be attached to the stock gyro mounting location using hot glue, magnets, etc, or in can just be slipped over and not hard mounted as its unlikely it will fall off. This also means you can use the centre console if you're using the stock gyro location

I designed this centre console as I was wanting to make a scale interior with the RMX which I don't see often. I printed this using the ender 3 but can be printed by any fdm printer and maybe even a resin printer but would recommend fdm

one file has a slot for a 15mmx 3mm magnet however a small piece of styrene or other similar material may be needed to attach the magnet to a corresponding magnet on the chassis itself (gyro mount)

This design requires supports, I did supports everywhere but you could probably get away with supports only touching build plate to save time/ material but do at your own risk.

design overall size (CM) 7 length 2.4 width 3.7 tall ( at highest point)

The print will take approx 3 hours.

Use 50% cubic infill with a 0.2mm layer height

This model was designed for an fdm printer but may work with a resin printer, however only fdm has been tested.

Material: PLA