The OEM magazine replacement for the APEX/SHS isn't available state-side so made an adapter to the bizon to accept the Matrix Bizon PP-19 magazine that can be purchased on Evike. Additive modification is required to the magazine as well.
BOM:
1x 1/8"x1" roll pin (purchased a set from Harbor Freight)
INSTRUCTIONS:
- Punch in 1/8"x1" into the Front Magazine Tab
- Remove any mock flash hider/tracer
- Install Front Magazine Tab w/ roll pin, roll pin should be facing farthest away from the airsoft replica
- There's an alignment nub that will align with the notch
- Re-install mock flash hider/tracer, this is necessary to hold the Front Magazine Tab w/ roll pin in place
- Dry fit the Magazine tab onto the tab of the Matrix magazine
- May need to file to fit on
- Use superglue to adhere the Magazine tab onto the Matrix magazine
- May need to file for the magazine catch to sit properly
Printed with ABS, 100 percent infill, 0.16 layer