Slim Wallet - for 7 cards and cash by MakerVerse Designs

MakerVerse Designs

Tools>Gadgets

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

Creality Ender-3 S1

0.15mm layer, 3 walls, 15% infill

Designer

3.1 h

3 plates

4.4(7)

0.15mm layer, 3 walls, 15% infill

Designer

9.5 h

3 plates

Boost

103

158

Released

Description

Updated Version available:

https://makerworld.com/en/models/446664#profileId-353166

A slim wallet that offers space for 7 cards and a drawer for cash.
I looked for a long time for a wallet that had enough space for cash, but I couldn't find one so I made this one myself.

Important: Some information about printing:

The wallet is printed standing up
No support is necessary.
First, the WalletConnector and WalletDistributer must be printed. Then the WalletCase.
In the wallet case I added an "M600" command at layer 39 so that the printing then stops. You have to do this by yourself in your slicer!!!
At Layer 39 the print will stop. Now insert the previously printed WalletConnector and WalletDistributer as in the picture below.
Then you continue the print. The printer will now print over the two parts.
Note: If you have problems with the cards not staying in, you can put cloth or glue like in the picture below.

Have fun with it and leave a like or subscribe if you like it!

If there are any suggestions for improvement, feel free to write a comment.

Comment & Rating (10)

@Zuricos

Print Profile

0.15mm layer, 3 walls, 15% infill

This is the first 3d Printed wallet that worked. Very nice and clever design. That thing with the freely moveable slider got me. 👌

@cryoglobe

it's indeed well designed ... but it's a bit too loose in my case ( print with my A1 ) I could not take it in my pocket an trust it to keep everything safe :( and not loosing everything Maybe adding a cover with a snap fit could help ?

@yrulookingatdee

Print Profile

0.15mm layer, 3 walls, 15% infill

pretty well

@cryoglobe

Nice job ... but I do have a bit too much of tolerance ( printed with my A1 ) I do not really understand your point to add some glue or tissue ( that should be glue , I supposed ) Could you maybe design a cover ( tie fit ) that could make all this in security ? Can't use it like that , too risky a lost the card(s) or even the small drawer :(

@jessiewbailey

Print Profile

0.15mm layer, 3 walls, 15% infill

Support Issue:Seems to need supports, the lever came out as a big mess

@cryoglobe

it could be because you did print with something else than 0.15 layer height ... ? At 0.15 , layer 39 is then 5.9 mm height , At 0.2 , you have to pause at layer 29 so 5.8 mm height If not , the blue part will be printed in the air

(Edited)