Under Desk Headphone / Audio Jack Extender and Anker USB 3.0 Hub mount

This is an under desk audio jack and USB hub mount, using a Anker 4 port ultraslim hub.  The whole thing mounts under the controller for my uplift desk with an Ikea Gerton solid wood top, but it should also be mountable without the controller too.  It uses a pair of cable strain relief boots which I printed in TPU, and I recommend using TPU for the boots. However, I did add an untested solid cable boot which can be printed in PLA or PETG (Audio_extension-1H-CABLE-SR-PLA-A.stl and Audio_extension-1H-CABLE-SR-PLA-B.stl). If you print the solid cable boot please provide some feedback.

If you only need an under desk audio jack, you can check out the model below:

https://makerworld.com/en/models/391493

This is designed to use the following parts:

MillSO 3.5mm Headphone Extension Cable
https://www.amazon.com/MillSO-Headphone-Extension-Auxiliary-Headphones/dp/B07W7JQ673/

And the USB hub is an Anker 4-Port USB 3.0 Ultra Slim Hub
https://www.amazon.com/Anker-Extended-MacBook-Surface-Notebook/dp/B07L32B9C2/

It was mounted with some #6 screws but I think #8 would work too.

There is also a pair of small cable management clips (for one or two cables), which can be mounted with some small screws or double sided tape.

To print the cable boot, I used PRILINE TPU which is a less flexible TPU (but works well for this).  Any TPU should work though.

https://www.amazon.com/PRILINE-TPU-1KG-Filament-Dimensional-Accuracy/dp/B074DV9JMX/

Part is not oriented for printing. If you print one, please post a make.

The STEP file is included for easy remixing.

(imported from Printables)

If you find these models useful, please post a like or a comment with some pics of your prints. 

You can find the other things I'm working on at my blog here.  You can also follow me here or on Printables, to see what new stuff I post.  If you would like to support my work, you can Buy Me A Coffee using this link:

https://www.buymeacoffee.com/mystoopidstuff

Thanks for looking!