Rear-view mirror car phone holder, only 5 parts
Copyright Claim
Rear-view mirror car phone holder, only 5 parts
Boost
2
0
1
Print Profile(4)
PLA, 1 plate, 0.25mm layer, 2 walls, 10% infill
Designer
4 h
1 plate
PETG, 1 plate, fast, 0.25mm layer, 2 walls, 10% infill
Designer
5.3 h
1 plate
PETG, 1 plate, 0.2mm layer, 2 walls, 15% infill
Designer
6.8 h
1 plate
PETG, 4 plates, 0.2mm layer, 2 walls, 15% infill
Designer
8.3 h
4 plates
Boost
2
0
1
0
3
0
Released
Description
I designed this phone holder to be easy to use, easy to print, and compatible with a variety of vehicles. Only two knobs needed for quick adjustments. Tension clip holds phone in portrait mode, and can accommodate large phones with cases. I've been printing my prototypes in PLA, but recommend printing PETG for warmer climates.
The large clip slides on the long rod's clip. Short screw attaches the hanger and holder together. Long screw is for adapting to variety of rear-view mirror rod widths.
Comment & Rating (1)
All
Definitely print this in PETG, my PLA version has already become brittle under the hot sun in the car and I've snapped a couple of parts. Going to reprint them in PETG. I'm also hoping to have a version 2 of this design soon.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld