No Print Profile yet. Add one to earn points.
In the middle of the parts there is a hole with a diameter of 16mm, it's for a wooden (or any kind of material) stick, that way the mace won't be flimsy when you glue it together.
There are also two 5mm holes for two metal sticks, you can skip this probably but I recommend putting any kind of sticks in, to securely keep the mace parts from rotating after you glue them together (I myself decided to just print a couple of long 4.5mm diameter sticks and put them into the holes to make sure all the parts are aligned)
You must print:
2x"blade with hole 1"
2x"blade with hole2"
4x"blade 1"
4x"blade 2"
1x “pole ring”
1x “ending 1”
1x “ending 2"
1x “top mace 1”
1x “top mace 2"
1x “top mace 3”
1x “pole 1”
1x “pole 2”
1x “handle bot”
1x “handle mid”
1x “handle top”
You don't need any supports!
Please post a make once you're done :)
CREDITS: Initial model was made by “VertexDon”, I based the whole model on it and made it printable.