Venom Hueforge
There are multiple color swaps required if you only have a single AMS system. You can swap out colors when they are no longer used while the print is going or add pauses to the gcode to swap the filament.
Slice with Classic instead of Arachne because Arachne takes a very very long time.
If printing on X1C, disable purge tower and Automatic Flow Calibration to make sure there is enough room on the bed.
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
Swap Instructions:
Start with Black
At layer #7 (0.4mm) swap to Blue
At layer #12 (0.6mm) swap to White
At layer #20 (0.92mm) swap to Black
At layer #22 (1mm) swap to Red
At layer #26 (1.16mm) swap to White for the rest.