Ever wanted your wall/door/ceiling/living space to flip you off? Print your very own wall mountable middle finger!

Just drill a hole or two, smush in a plug, align the wall mount bracket, screw in the screw and slot in the piece of decor!

NOTE: just make sure to get a screw that fits! The hand has a slot in which the screw head has to fit inside! Give it a print, measure and find a screw head that fits!

The model scales very well. so scale it to your hearts content!

The infill and walls are optimized layer modified! navigate over to the object tab and check out the settings for the layers! you can adjust them as you need if you scale the model.

Support is also optimized. You can play with the painting as you wish, maybe hide the seams or do some magic.. or just flip it off

Or just remove the modifiers and let the model be one consistent setting! (results in longer print times, but easier slicer navigation)

On smaller scale models, the wall mount bracket might be a bit sticky with the interface to the hand, you can remedy this by heating the bracket a tiny bit and slotting it into the hand to help it form a smooth interface.